Acoustic Resilient Joist Cap

Acoustic Resilient Joist Cap

USES:

Timber and MasonryBuilds
Part E Compliant System
Direct to Joist Application
Non specialist installation
-45°C to 105°C
Heat shrinkage less than 1% at 80°C for 96 hours

BENEFITS:

No Wastage!
No structural change over time
Lightweight
CFC, HCFC free, zero ODP
Very low toxic fume and smoke emissions
100% recycleable
Moisture resistant
Rot proof

Download PDF

Direct to Joist - Acoustic Joist Caps Part Code AC200 A superb, easy to fit, Direct To Joist System, engineered as a Part E compliant acoustic joist treatment, to save the developer time and money. It can be used in both new build and refurbishment projects for timber and masonry builds. This product, used upside down, can also provide the resilient layer required for customers to make up their own resilient battens. If the product is used in this manner, on a concrete floor, impact improvements in the order of: : Delta L_w22dB with a standard batten Delta L_w24dB with a deep batten can be expected. Robust Details only require an improvement of Delta L_w17dB If the product is used in this manner, on a timber floor, improvements in the order of: Delta R_w+C;_tr14dB and Delta L_w20dB can be expected. Robust Details only require an improvement of: Delta R_w+C;_tr13dB and Delta L_w15dB
Proven to be the most effective means of achieving superior sound attenuation, the mass of the structure is placed above the resilient layer. The product is then simply placed over the joists before the mass of the floor is added. The cap is suitable for both rough-cut and planed timber joists.
Installation Guide Care should be taken to comply with all relevant Safety and Building Regulations. The Joist Cap can be fitted from either above or below the joists and even before the joists are fitted. The jaws of the caps are slightly tapered in to ensure a tight friction fit. Simply open the jaws and sit the cap over the joist ensuring the base is located tightly with the joist surface. In all applications, our perimeter isolation strip must be used so the floating floor is fully isolated for the structural floor and walls.

Incorporating the latest changes to the Approved Document E 2003, the minimum and maximum sound insulation requirement for separating floors are as follows:

Conversion

New Build

Airborne Sound Reduction D_nTw+C;_tr

43dB or greater

45dB or greater

Impact Sound Level L_nTw

64dB or less

62dB or less

To comply with the requirements of the Approved Document E 2003, the Acoustic Joist Cap sound insulated separating floor has been tested in accordance with BS EN ISO 140-6:1998 and rated in accordance with BS EN ISO 717-2:1997.
It was tested at the BRE - 234174: L207-005 and L207-006

You need to either upgrade your Flash Player or install Flash or turn on Javascript to view missing content. You can download the pluggin from Adobe Here.

Tested Performance of the Above Structure (Without the 19mm Plank):-
  Airbourne              Impact
R_w=63dB (C_tr-12)    L_n,w55dB
R_w + C_tr= 51dB

Further improvements can be made by placing 19mm Gypsum based plank over the Joist Caps before installing the 18mm T&G Chipboard.
If this is undertaken first then improved results will be in the order of:
  Airbourne              Impact
R_w+C_tr= 56dB    L_n,w50dB

GENERAL PHYSICAL DATA
Length:	2m
Width:	50mm
Thickness:	12mm
Density:	30kg/m³




All information contained in these details is given in good faith but without warranty. Custom Audio Designs reserves the right to alter the specifications of any product without notice.

©Custom Audio Designs 2007