Masonry Isolation Strip Wall Vibration Isolation
Independent Acoustics and Noise Control Specialists		  

6010XHT | Acoustic Wall Isolation Strip | Blockwork Vibration Isolation | Rubber Isolation Strips
Masonry Isolation Strip Wall Vibration Isolation
Masonry Isolation Strip Wall Vibration Isolation Masonry Isolation Strip Wall Vibration Isolation Masonry Isolation Strip Wall Vibration Isolation Masonry Isolation Strip Wall Vibration Isolation Masonry Isolation Strip Wall Vibration Isolation
Masonry Isolation Strip Wall Vibration Isolation
Fire and Acoustic Intumescent Backbox Liner
USES:
  • Electrical sockets and switches
  • Suitable for single or doubles
 BENEFITS:
  • Easy DIY Installation
  • Easy to cut
  • 2 hour fire rated
  • Highly efficient
  • Part E and Part B compatible
Download PDF
  Acoustic Intumescent back box lining
Our intumescent and acoustic lining pad is designed for lining electrical socket boxes in drywall constructions. The mouldable pads fit easily into socket boxes to reduce sound travelling through the walls whilst providing flexibility when fitting avoiding accidental tearing or puncturing.

Cutting an electrical socket opening in a drywall partition can reduce its acoustic performance and resistance to fire which could therefore resul in non-compliance with Part E and Part B Building Regulations.

Our pads are the acoustically tested, intumescent solution, complying with Building Regulations.

Maintains acoustic integrity of the wall, with a rating of up to 69dB RW
Supplied in full reels of 3.6m x 178mm or individually.
Each strip is 178mm wide

Each reel is sufficient to cover at least 27 single boxes or 20 double boxes

Installation Internally

  • Use the printed grid to measure the length of pad required - approx. 6 grids for a single box and 8 for a double box.
  • Cut the pad and remove the protective paper from one side.
  • Make a slit for the cable to pass through the pad.
  • Press the pad firmly in place in the socket box ensuring adhesion on all surafces then mould into the corners.
  • Remove the second protective paper and trim any excess away.

    Installation Externally

  • Use the printed grid to measure the length of pad required.
  • Cut with a sharp knife and remove protective paper from one side.
  • Press the pad firmly over the back of the socket box to ensure adhesion on all sides.
  • Remove the second protective layer.

    • Xetal 8000 E-cousti soundproofing membrane

    All information contained in these details is given in good faith but without warranty.
    Custom Audio Designs reserves the right to alter the specifications of any product without notice.
    ©Custom Audio Designs

    Valid HTML 4.01 Transitional